How to use the wheel balancer(tyre balancer )?

First, inflate the tire to the proper air pressure, remove the lead on the rim, remove the stones in the tire groove, and clean the rim.

Then, install the wheel balance shaft with the tire mounting surface facing inward, select the appropriate vertebral body, and lock the tire with the locking device.

Next, turn on the power of the wheel balancer, pull out the ruler to measure the distance from the rim to the balancer, rim width, rim diameter, and enter the measured data in order. Press the start button, the tyre balancer will start the tire rotation, and the measurement will start. Be careful not to stand near the tire to avoid danger. The balance machine measured data automatically stops,

Finally, rotate the tire until the position light on the side of the wheel balancer is fully lit (different models display differently). At the highest point of the side that is fully lit, which is 12 o'clock, type the corresponding weight of lead. Same for the side

Repeat the above steps until the wheel balancer shows 0 (less than 5 grams, because there is no lead block less than 5 grams, and the balance machine does not show an unbalance amount of less than 5 grams). The tires must be removed after the balance is completed.